Escape Pocket Tag

Click image to enlarge

 Tag is made from two ShapeXpress cut pieces.  Tags inside pocket are also ShapeXpress cut

Difficulty rating

• Required supplies:
• Fiskars Rectangles Template (5” x 3” and 3.5” x 2”)
• Fiskars Squares Template (3” x 3”)
• Fiskars Eyelet Tool (1/8” and 3/16”)
• Fiskars Tape Runner and Fiskars Craft Mat
• Cloud 9 Design Woodstone Collection Beach Chunky Stripe Photo Banner Paper
• Cloud 9 Design Woodstone Collection Beach Photo Banner Stickers
• Fiskars Rope Border Punch
• Other: white cardstock, 3/8” white grosgrain ribbon, white (1/8”) eyelets, sandpaper,

Instructions (Print version)

1. Using the Ultra ShapeXpress, Craft Mat and Rectangles Template, cut out a 5” x 3” rectangle from the Beach Chunky Stripe paper (position template to cut mainly yellow). 
2. Cut two 3.5” x 2” rectangles from white cardstock.
3. Use the Squares Template and cut a 3” x 3” square from the Beach Chunky Stripe paper (position template to cut mainly blue with a yellow stripe).
4. Lightly sand edges of large rectangle and square pieces.
5. Use the Rope Border Punch to punch once in the center top edge of the square.
6. Run the large rectangle piece through the Paper Crimper. 
7. Position square over bottom of large rectangle and using the 1/8” Eyelet Setter, set a white eyelet (1/8”) in each corner through both pieces to create a pocket.
8. Use the 3/16” Eyelet Setter and set a white eyelet in top of tag.
9. Place a ribbon through eyelet.
10. Use the Non-Stick Scissors to cut out words and photo sticker from Beach Photo banner stickers.
11. Place photo sticker on a white rectangle piece and slide both white rectangles into pocket.
12. Mount sticker words onto white cardstock and trim around leaving a border.

Mount words onto front of tag with foam tape.

Options: Use this same design to create birthday, holiday, thank you tags, etc. – just change color and embellishments.  This would make a perfect holder for a gift card.